Remote starters usually are not available as a manufacturing facility possibility on the Toyota Corolla, but they might be put in aftermarket by anyone with the proper instruments and a robust understanding of automotive electrical systems. You will need to keep in mind that the Toyota Corolla could also be outfitted with an optional factory safety system and/or ignition immobilizer that must be interfaced to ensure correct remote begin operation. If the automotive is provided with an immobilizer, further equipment will likely be required.
Toyota Corolla Remote Starter Installation Instructions
1. Remove the below-dash panel. This provides you with access to the Corolla’s ignition wiring. Find the primary ignition energy, ignition, accessory, and starter wires in the principle ignition harness. The horn wire may be discovered in this harness as properly, if it is wanted for the installation. Confirm all wires with a digital multi-meter and strip a small amount of insulation from them.
2. Remove the motive force’s facet kick panel. This will present entry to the door lock and unlock wires in addition to the parking light, brake light, and safety wires. Once these wires are located and examined for operate with a digital multi-meter, the wires may be stripped of insulation.
3. Connect the remote start wiring to the suitable wires within the car. Solder all connections and seal them with electrical tape. When potential, run all aftermarket wires subsequent to manufacturing unit wire harnesses, and connect them with nylon wire ties.
4. Mount the antenna to the windshield. For maximum range, mount the antenna as close to the center of the windshield as possible.
5. Test the unit for correct operation. Verify the correct operation of the remote begin and all installed functions. Arm the manufacturing unit alarm, if geared up, and confirm that the alarm does not go off when the automotive is started.